| 1. | Usually the number of holes in the spinneret determines the number of filament in the yarn . 一般喷丝头细孔的数量决定了纱中长丝的根数。 |
| 2. | Hole density : the number of holes per unit area on a pcb 孔密度: pcb上单位面积上的孔数。 |
| 3. | With the least number of holes put spheres impacting scoring can be 用最少的次数把球打进球洞即可。 |
| 4. | A number of holes border the shoreline creating wonderful views 与海岸线接壤的球洞造就了美丽的景观。 |
| 5. | Number of holes in a blob 粒子内的孔数目 |
| 6. | The choice effect of colour is subject to the numbers of holes , the shapes of holes , the precision of size 荫罩上孔的数量,孔的形状和尺寸的精度,都会影响彩色显像管的选色效果。 |
| 7. | While this manual intervention may be acceptable for manufacturing companies if but a small number of holes or workpiece must be machined , as quantities grow , so does the likelihood for fatigue due to the tediousness of the operation 如果只有数量不多的孔或工件要加工,这种人为干预对制造厂来说可能是可以接受的,但是,随着生产数量的增加,由于操作乏味而产生疲劳的可能性也增大了。 |
| 8. | Game controls : very simple game , and control the mouse in the direction of small balls , next to the blue box said the strength of the ball , the more blue , the greater the power of the ball , with the least number of holes put spheres impacting scoring better 游戏操作:很简单的游戏,鼠标操作控制小球的方向,旁边蓝色空格表示球的力量,蓝色越多,球的力量越大,在最少的次数把球打进球洞为好。 |
| 9. | At the same time the number of holes for liquid flowing , gas flowing and blocked to the number of total holes was defined as liquid flowing ratio , gas flowing ratio and blocked ratio . the experiment was made with in - diameter 500mm column using water - air system , the ratio was first delected in detail by multi - path conductivity gauge for the compound tray with free area 20 % and 25 % respectively 采用多路电导测试仪,在直径500mm的冷模塔内,以空气-水为介质,首次较系统地测量了开孔率为20和25的复合塔板的通气、通液和阻塞筛孔的数量比例,获得了通气率、通液率和阻塞率随气液变化的基本规律。 |
| 10. | The results show that : the whole bit wear process can be divided into three phases ; the regularity of the machining time per hole with the number of holes machined is close to a periodic variation ; higher machining efficiency or working life can be obtained when the drilling pressure and the wall thickness of the bit are advisable 发现钻头的整个磨损过程可分为3个阶段;孔加工时间随孔数近似呈周期性变化;钻压和钻头壁厚适当时,可获得更高的加工效率或者工具寿命。 |